hello world!

6 Top Home Floor Sanding Mistakes

We all want our home to be beautiful and clean, but sometimes the floors can get in the way. Home sanding is one of those things that people don't think about until it's too late. It might seem like a simple task, but there are many mistakes that can lead to frustration and wasted time if you're not careful!

In this article, we'll discuss 6 common mistakes made when sanding floors at home so you avoid them on your next project.

Sanding too Fast

When you are sanding your floor, the grain of the wood is getting pushed down by your sander's motion. If you go over a spot twice as quickly or three times as quickly it will have an uneven effect on the surface and leave streaks in your finish. To avoid this mistake, plan for about 12-15 minutes per square foot when using a belt or disk sander, and between 20-30 minutes with an orbital hand sander like these.

Not using enough water

Using water during sanding is extremely important. If you don't have enough, your sander will leave scratches and gouges on the floor that are difficult to fix. If you use too much water it will cause a glaze over the wood which makes for an uneven finish once dry.

To avoid this mistake, always test out the amount of water needed on a small patch where no one is going to walk before starting with your project. You can even keep a spray bottle or mop nearby if working by hand so everything stays wet as you go through each section.

Not Sanding in the Direction of Grain (or Against)

The direction that your grain runs should also be taken into consideration when sanding floors at home; it's not always going to be in the same direction. If you don't sand against or with your grain, it will leave a wavy surface on the floor that looks very messy and unprofessional. To avoid this mistake, always check where the grain is running before starting any sander project so you can work with it instead of against it!

Using a Sander With Worn-Out Sandpaper Strips or No Sandpaper at All

If you are using an orbital hand sander like these ones there are two important things about their sanding strips: they wear out quickly and should only ever be used once. When your paper starts wearing down too much, switch to another piece for better results or use an entirely different tool if needed.

Not Starting and Stopping on a Clean Section of Floor

If you aren't starting and stopping at the same point when sanding your floor, there will be places that have already been finished or missed entirely. This is why it's important to always start with an area where no one walks like walls near doors. With belt sander projects, this can mean switching between different slots depending on how far you are going from room to room; just make sure everything gets done by moving forward through each section!

Letting Dust Accumulate During and After Your Project

In addition to preventing damage, always sweep up excess sawdust from electrical tools like these from Home Depot. Sawdust can be very combustible when left on wood floors because moisture has already been removed by sanders leaving nothing but dry particles that catch fire easily if ignited.

Conclusion

Everyone has a different floor in their home, and they all need to be maintained. Home sanding is the best way for homeowners to get rid of any irregularities on wood floors so that they can lay flat again after installation or refinishing like this one here! If you follow these simple guidelines your next project will go smoothly from start to finish without creating additional work for yourself down the road.

envelopephone-handsetmap-marker linkedin facebook pinterest youtube rss twitter instagram facebook-blank rss-blank linkedin-blank pinterest youtube twitter instagram